HomeFaxSending after Specifying a Relay Station (Line specification)

Sending after Specifying a Relay Station ([Line specification])

About line specification

When multiple lines are used, you can select a line for sending a fax.

Using additional lines enables you to send a fax using an idle line or assign lines to send a fax.

  • If the line specified to send a fax is not available because it is busy for communication, the job is placed in the standby state until the communication is completed.

  • When registering destinations with an address book, you can configure the lines used to send faxes in addition to registering fax numbers.

  • This function cannot be used together with the following functions.
    Polling TX, Polling TX (Bulletin Board)

  • [TX/RX Settings] - [TX-Line Auto Switch Setting] (Here)

Preparation required to use this function (for the administrator)

Configure a specific function for additional line. If you set a specific function for each line, you can use each line for a different purpose.

For details on the setting procedure, refer to Here.

  • You cannot specify a line if [Multi Line Settings] is set to [RX Only].

Operation flow

  1. Load the original.

  2. Tap [Fax] on the home screen.

  3. Specify the destination.

  4. Tap [Line Settings].

  5. Select a line used for transmission in [Select line], and also tap [OK].

  6. Use the Start key to start transmission.